 |
The motor is pre-installed into the roll-up tube and
is complete with a 15 metre long, 8mm diameter,
7 core YY control cable which feeds back to the
main control panel. |
|
The cable can be extended using standard 10amp
electrical connections, but the overall cable length
should be limited to 30 metres. Please ask at the
point of order or specify on the Aquatronic Roller
order form if extra cable is required. |
|
The control panel includes an adjustable time delay
function which allows time for the user to move
from the control station (either key switch, push
button or radio remote) to the pool side to begin
guiding the cover. For the key switch and push
button this time is adjustable up to 30 seconds,
for the radio remote this is adjustable up to 5
seconds - this should be considered when
planning location of the control station. |
|
The key switch is a 3 position ‘stay-put’ switch and
is connected to the main control panel by a
minimum 0.5mm2 standard 3 core cable (not
supplied). The push button is pre wired with a
15m signal cable. |
|
If ordered with a cover, the cover will be pre-secured
to the roller and calibrated for basic start
and stop position, but some fine tuning of
calibration will be needed on site at point of
installation. |
|
Covers are connected via a 6mm nylon rod fed
through the back edge of the cover / connection
piece (please see page 194 for full options).
Please inform of distance from pool edge to final
planned roller position at point of order. |
|
For pools with limited surrounding space, the motor
mounting plate can be used as a wall mounting
plate for both the motor and / or non-motor end of
the roller. |
|
Pricing is for roller only. Please price for cover
connection piece and towing kit separately. |
|
The Aquatronic roller is a semi-automatic product.
Floating covers require a towing boom and manual
guidance to manoeuvre them on and off the pool. |
|
Suitable for pools of up to 15m x 7.5m or covers
up to 112.5m2 where the maximum width is 7.5m. |
